Gmc 2003 Savana User Manual download pdf (Page 14)

Replacing the Rear Seats

A CAUTION:

A that isn't locked cntG place properly can

Tnove around in a cctlj$ion cr audden slop.

People in the vehicle could be injured. Be sure

tq lock the seal into place properly when

Installing It.

A CAUTION:

A safety bell that is improperly routed, not

properly attached, or twisted won’t provide the

protection needed in a crash. The person

wearing the belt could be seriously injured.

After raising the rear seatbacK, always check

to be sure that the safety bells are properly

routed and etlached, and arc not twisted.

1. Position Ihe seal inlo ihe open slots in bolh rails.

Push the seat Forward in the rail, hooking both

seat bases nntq the pins inside of the rails.

2. To install the locking pins at the rear of the seal

base, locate the hole in the rail lor Ihe pin. II is

found on the inboard side of the seal. If the vehicle

has floor mals, pull tha flap thaf has been cut

inlo Ihe rna1

3- In sen the black or white locking pjn into the seat

base. Po^sjblo slight seat pushing may be needed

fo line up the pin with the base, Romember,

each pin has its own side. The pin with the white

handle marked “R" musl be installed on the

passenger’s side and the pin with the black handle

marked “L" on the driver's side.

1’7

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 184 185

No comments

Gmc 2003 Savana User Manual Page 14