Gmc 2007 Sierra User Manual download pdf (Page 292)

Finding a Station

AM FM: Press this button to switch between FM1,

FM2, or AM. The display shows the selection.

TUNE: Turn this knob to select radio stations.

oSEEK p: Press the right or the left arrow to go

to the next or to the previous station and stay

there.

To scan stations, press and hold either SEEK

arrow for two seconds until you hear a beep. The

radio goes to a station, plays for a few seconds,

then goes to the next station. Press either

SEEK arrow again to stop scanning.

To scan preset stations, press and hold either

SEEK arrow for more than four seconds until you

hear two beeps. The radio goes to the ﬁrst

preset station stored on the pushbuttons, plays for

a few seconds, then goes to the next preset

station. Press either SEEK arrow again to stop

scanning presets.

The radio only seeks and scans stations with a

strong signal that are in the selected band.

Setting Preset Stations

Up to 18 stations (six FM1, six FM2, and six AM)

can be programmed on the six numbered

pushbuttons, by performing the following steps:

1. Turn the radio on.

2. Press AM FM to select FM1, FM2, or AM.

3. Tune in the desired station.

4. Press and hold one of the six numbered

pushbuttons until you hear a beep.

Whenever that numbered pushbutton is

pressed, the station that was set returns.

5. Repeat Steps 2-4 for each pushbutton.

292

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 673 674

Comments to this Manuals

No comments